Shows how to set the accuracy stick against a pole so it reads an accurate tilt.
Overview video
Setting Up the Scale Stick for Pole Collection
1. Position the scale stick at the pole 0:03
Place the scale stick directly against the pole.
Make sure the bottom of the stick is touching the ground.
Confirm both targets are contacting the pole tightly before moving on.
2. Adjust the legs for stability 0:21
Kick the legs out slightly to create a stable stance.
Pull the legs back into the desired position.
Press the two quick release buttons to lock everything in place.
3. Verify setup on risers if present 0:34
If the pole has risers, place the stick on the riser as needed.
Confirm the setup still allows accurate measurements.
Recheck that both targets are close to or touching the pole itself.
4. Confirm target alignment for accurate tilt readings 0:44
Inspect both targets to ensure they are positioned evenly against the pole.
Avoid having one target pulled away while the other touches the pole.
Remember that uneven target placement can cause the app to read an incorrect tilt.
5. Final upright check before collection 0:52
Stand back and confirm the stick is upright.
Verify both targets are close to or contacting the pole.
Proceed with pole collection only after the setup is secure and aligned.
Cautionary Notes
Do not leave one target pulled away from the pole while the other is touching it; this can distort tilt measurements.
Ensure the bottom of the stick is on the ground before locking the legs.
If the stick feels unstable, reset the legs and recheck contact points before collecting data.
Tips for Efficiency
Lock the quick release buttons only after confirming the stick is positioned correctly.
When working with risers, focus on target contact rather than the exact surface the stick rests on.
Perform a quick visual check of both targets and the pole before starting collection to avoid rework.
Related articles
See Set up your accuracy stick for the full written walkthrough, and Measure a pole for what comes next.